Leather stripper and degreaser – preparation before leather paint


Optimal leather preparation before renovation and repainting
The SOFOLK leather stripper and degreaser is a technical-grade acetone, purer and more powerful than the acetone sold in supermarkets or DIY stores. It dissolves grease, ingrained sebum and old protective layers (varnish, finishes) to take the leather back to bare before it is repainted.
The durability of the renovation depends on this preparation: on a clean, degreased surface, leather paint grips firmly, spreads evenly and lasts.
Please note: this is not a care product. Its action is deliberately strong and reserved for renovation work. For everyday care, use the stain remover cleaner.
Which surfaces can it be used on?
- Leather: car seats, sofas, armchairs, saddlery, leather goods and shoes, before repainting or applying a new varnish.
- Steering wheels: almost always greasy, a steering wheel is degreased perfectly with the stripper before using the leather steering wheel renovation kit. Allow 3 to 4 passes.
- Faux leather and leatherette: with care. Test on a hidden area and, if necessary, dilute the stripper with 10 to 20% water to make it less aggressive.
- Plastic: to degrease parts before applying the SOFOLK plastic paint.
- Metal, aluminium and stainless steel: it degreases them just as effectively.
Instructions for use
- Protect yourself: gloves are essential, safety glasses recommended; work in a well-ventilated room, away from any flame or heat source.
- Test on a hidden area, especially on faux leather.
- Apply: soak a paper towel, never pouring the product directly onto the material, then rub in circular movements, area by area, without pressing too hard.
- Wipe with a clean paper towel and repeat until it comes away clean.
- Leave to dry: the stripper evaporates very quickly and the surface is dry in under 5 minutes.
Slight discolouration is normal
Like acetone, the stripper dissolves varnish and finishes, and may also remove some of the original colour. This is not a problem, since the leather is going to be repainted. However, once stripped, the leather has no protection left: only use the stripper just before repainting.
What comes after stripping?
- On a sofa or armchair with difficult leather loaded with sebum: apply the adhesion primer, especially on the backrests and armrests. It is not always necessary.
- Repaint with the leather paint for sofas and armchairs or the leather paint for car seats.
- Protect the colour with the silky varnish.
Which size should you choose?
- 500 ml: more than enough for a 3-seater sofa or the complete interior of a vehicle.
- 1 litre: for a 4 to 5-seater sofa or a corner sofa.
Products mentioned on this page
-
PRIMER FOR PIGMENT DYESCreates the bond between the leather and the pigment leather paint
19.99 €
View product
-
LEATHER PAINT SOFAA colour that penetrates the leather without making it plasticky: it stays supple and soft
24.99 €
View product
-
LEATHER PAINT AUTOMOTIVE SEATSPenetrates and grips at the same time: a leather look, with no vinyl effect
24.99 €
View product
-
LEATHER SOFA VARNISHProtects the colour and grain of the leather from rubbing and dirt
20.99 €
View product
-
AUTO PLASTIC SPRAY PAINTPaints car plastics, and metal very well, inside and outside
24.99 €
View product
-
−17 %
Leather Steering Wheel Renovation Kit, Leather Steering Wheel Repair KitRepairs, recolours and protects a worn, cracked or faded steering wheel
44.99 €37.49 € View product
Available in 500 ML.
This product is suitable for renovating:
- Car
- Sofa, armchair
- Shoes, boots
- Jacket, coat
- Bag, leather goods
- Equestrian tack
- Boat
Learn more


