LEATHERETTE TOUCH-UP KIT FOR CAR SEATS: RECOLOUR AND PROTECT







250 ml of paint + 200 ml of varnish: enough for a whole seat
Shade of your choice: 22 standard colours, car maker colour charts or made to measure
No primer or fixer needed, applied with a roller or sponge
Satin, matt or gloss varnish, with UV protection
Bring the colour back to a leatherette car seat
Over the years, leatherette (faux leather, vinyl) loses its colour: a faded seat, dull edges, slightly peeling areas. This kit contains enough to repaint and protect the equivalent of a complete driver’s or passenger seat, in the shade of your choice. It is meant for leatherette that only needs colour: to fill small tears or cracks, choose the leatherette renovation kit instead, which comes with a repair paste.
What the kit contains
- 250 ml faux leather paint, made in the shade you choose. Its label reads “recolorant pigmentaire” (pigment dye): it is the same formula as for leather, and it bonds perfectly to leatherette with no primer or fixer.
- 200 ml varnish, satin, matt or gloss, with UV protection: it gives the finish and protects the colour from rubbing. If in doubt, choose satin, the most common finish in cars.
Choosing the shade
The 22 standard colours of the SOFOLK colour chart are made at no extra cost. To match the original colour, pick it from the car maker colour charts, from the RAL colour chart, or have it reproduced exactly from a 1 cm² sample of your leatherette. On screen, colours may look slightly different.
How to use
- Prepare: lightly sand with 240 to 400 grit sandpaper, pressing no harder than the weight of your hand, to break the original finish. Clean, then degrease with methylated spirit or with acetone diluted 50/50 with water.
- Test: on a hidden area, apply a few coats to check the colour and the drying: once dry, the paint must not feel sticky.
- Recolour: in the shade, between 10 and 25 °C, with the bottle well shaken, using a high-density foam roller or a sponge. Allow 1 to 3 coats (3 for very light colours, reds and yellows) and about 2 hours’ drying between coats at 20 °C. A brush helps in the corners.
- Protect: as soon as the last coat is dry, apply at least two coats of varnish, spread with a slightly damp sponge, flattening any bubbles. Do not use the seat before varnishing.
Our tip: add the multi-purpose catalyst to the paint and the varnish to make them more durable.
Touch-up or full recolouring?
A touch-up limited to one area may leave a slight difference with the rest of the seat. For an even result, recolour the whole part: seat cushion, backrest or bolster. The kit also suits the leatherette of a motorbike, a motorhome, a boat or a sofa.
Kit contents
This product is suitable for renovating:
- Car
Learn more


